EPDMpaperDeposit2016.pdf (1.22 MB)
Developing ethylene-propylene-diene rubber compounds for industrial applications using a sulfur-bearing silanized silica nanofiller
journal contribution
posted on 2017-01-18, 12:56 authored by Ali Ansarifar, Farhan SaeedThe loading of a sulfur-bearing silanized silica nanofiller in ethylene-propylene-diene rubber with 4.5 wt % of ethylidene norbornene diene content was increased progressively to 60 parts per hundred rubber by weight. The rubber compounds were cured via the tetrasulfane groups of the silane by adding sulfenamide accelerator and zinc oxide. The hardness, tensile strength, elongation at break, stored energy density at break, tear strength, Young’s modulus, M50-M300, compression set, cyclic fatigue life and bound rubber content of the rubber
vulcanizates were measured. With the exception of the elongation at break and compression set which deteriorated, the remaining properties improved and the rate of cure, optimum cure time and crosslink density benefitted also when the loading of silica was increased in the rubber. The bound rubber content was unchanged and the cyclic fatigue life of the rubber vulcanizate enhanced considerably when silica was added. Optimizing the chemical bonding between the rubber and filler via the tetrasulfane groups of TESPT reduced the chemical curatives in the rubber. This was a major improvement in health, safety and environment.
History
School
- Aeronautical, Automotive, Chemical and Materials Engineering
Department
- Materials
Published in
Polymer CompositesVolume
34Issue
12Pages
2019 - 2025 (7)Citation
ANSARIFAR, A. and SAEED, F., 2013. Developing ethylene-propylene-diene rubber compounds for industrial applications using a sulfur-bearing silanized silica nanofiller. Polymer Composites, 34 (12), pp.2019-2025Version
- AM (Accepted Manuscript)
Publisher statement
This work is made available according to the conditions of the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International (CC BY-NC-ND 4.0) licence. Full details of this licence are available at: https://creativecommons.org/licenses/by-nc-nd/4.0/Acceptance date
2013-08-12Publication date
2013Notes
This is the peer reviewed version of the following article: Polymer Composites, which has been published in final form at http://dx.doi.org/10.1002/pc.22609. This article may be used for non-commercial purposes in accordance with Wiley Terms and Conditions for Self-Archiving.ISSN
1548-0569Publisher version
Language
- en