Loughborough University
Leicestershire, UK
LE11 3TU
+44 (0)1509 263171
Loughborough University

Loughborough University Institutional Repository

Please use this identifier to cite or link to this item: https://dspace.lboro.ac.uk/2134/12367

Title: Efficient simulation of non-linear kerb impact events in ground vehicle suspensions
Authors: von Chappuis, Hubertus
Keywords: Vehicle Suspension
Tyre modelling
Spatial map concept
Multi-body system
Issue Date: 2013
Publisher: © Hubertus von Chappuis
Abstract: In the increasing competition which pervades the automobile sector, it is necessary to develop simple methods to enable prediction of suspension loading level envelope in an early development stage. For this purpose, the FORD specified standard driving manoeuvres, based on kerb strike and pothole braking, inducing worst case loading scenarios are employed. The damaging nature of these tests and the relatively expensive physical prototypes make simple simulation models essential. These models should cope with an initial rudimentary assessment, but must suffice to predict the maximum wheel centre loads with a reasonable degree of accuracy. Enhanced model features are required to represent edge-type tyre deformation and impulsive bumper deflection. State of the art approaches are physical tyre models extended to rim clash modelling and rheological bumper models embedded in an multibody system (MBS) environment. These enhancements lead to increased complexity. The thesis proposes a minimal parameter vehicle model, tailored to predict vertical suspension loads caused by the FORD kerb strike manoeuvre. Since the focus is put on model simplicity, an in-plane bicycle model is extended to 7 degrees of freedom. Nonlinear and hysteretic characteristics of the bump-stop elements are included through use of a spatial map concept, based on displacement and velocity dependent hysteresis. Furthermore, a static tyre model is described to predict the radial stiffness against penetration of an edge and flat-type rigid body geometry. The full mathematical model is derived on the basis of the shell theory and represented in terms of few geometrical input parameters. A distinct tyre model, representing the tyre belt as a multi-link chain is also derived to confirm the assumptions made in the simple mathematical model. Model validation is supported through experiments at both component and system levels. It is shown that the bumper map concept provides an accurate, yet simple alternative to a rheological model, if applied to polyurethane foam type bumpers. This approach is also confirmed for the tyre model, substituting a comprehensive physical model approach.
Description: A Doctoral Thesis. Submitted in partial fulfilment of the requirements for the award of Doctor of Philosophy of Loughborough University.
Sponsor: FORD
URI: https://dspace.lboro.ac.uk/2134/12367
Appears in Collections:PhD Theses (Mechanical, Electrical and Manufacturing Engineering)

Files associated with this item:

File Description SizeFormat
Thesis-2013-vChappuis.pdf11.73 MBAdobe PDFView/Open
Form-2013-vChappuis.pdf899.65 kBAdobe PDFView/Open


SFX Query

Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.